Troubleshooting The Vexilar FL-18

If you are looking for a good used Vexilar for sale, the Vexilar FL-18 model will be an excellent choice. This model is a depth finder that doubles as a fish finder. The Vexilar FL-18 can be installed on a craft’s exterior or inside of its hull. If you end up with a device that stops to function properly, make use of the troubleshooting tips that I will be providing you in this article.

Two of the most common causes why a Vexilar fish finder doesn’t function well would be problems with its battery or transducer. You need to inspect both of these parts so that you can determine which one is causing the malfunction. In addition, you also need to do some minor adjustments so that you can determine the most appropriate solution to your problem. The first thing you can do to try out the problem on your Vexilar FL-18 would be to check its battery. If the battery is the problem, your unit will most likely fail to function well when you turn it on or if it only works for a short period of time before it shuts down. If this happens, make sure that the 3-point pin connector of the device is properly seated in the rear of the device. To do this, follow the cord attached from the device to its power source.

On the other hand, if your device’s screen fails to display the depth of the water underneath you or fails to target correctly, then your transducer might be misaligned or improperly installed. If this is the case, the display on your Vexilar FL-18 will most likely be difficult to read or understand. In addition, the device may also not function well when your boat is moving. To ascertain maximum performance, you need to install your transducer just underneath your boat but make sure that it is deep enough so that the water can constantly cover its face even when your boat is moving fast.

This entry was posted in Sports & Outdoors and tagged , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *


You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>